Infiniton HG-FL3 Manual De Usuario página 18

be turned off by the control knob.
Changing the cylinder:
Turn off the cylinder valve fully (clockwise) and allow the heater to fully cool before removing
and replacing the cylinder. Do not attempt to remove the regulator while the heater is still
running.
Maintenance:
Before maintenance and cleaning, gas heater supply must be turned off, the heater should

be cold. Don't attempt to clean the heater while it is in use.
The heater should be checked annually by a qualified technician for safe operation and in

order to detect any faults.
In case any faults are detected while in use, stop using the heater and contact your dealer

for advice.
Periodically clean the exterior and storage area of your heater to remove dust and fuzz

build upon the surfaces of the ceramic components.
Do not use abrasive products to clean the heater.

Check the pilot light while it is operating. It should burn steadily. If it flickers or there is a

yellow flame, the heater should be checked to make sure it is properly functioning.
In case any parts need replacement, they must be replaced only with parts from the

original manufacturer. The use of incorrect or substitute parts might be dangerous and will void
any warranty.
When the heater is not in use, we recommend that it is covered, or kept in its carton to minimise
the accumulation of dirt that may occur.
Technical assistance before calling for further help
The heater doesn't light:
Check the gas cylinder to make sure that it is full.

Check the regulator to make sure that it is properly attached and the cylinder valve is

turned on.
Check that the instructions have been followed correctly.

If this happens after the cylinder has been changed it would be due to:
Air in the cylinder. Hold the control knob down for a longer period of time until the pilot

and main burner light. Switch to the 3-HIGH setting.
The cylinder may have been excessively cold. Allow the cylinder to reach room

temperature before attempting to start the heater.
The heater turns off by itself:
If the heater goes out on continuous working, repeat the operation, following the

instructions faithfully.
If it goes out soon after 30 minutes or so, it means that it is operated in a badly ventilated
