Available Accessories - Casals QUANTICA EEC Manual De Instalación, Operación Y Mantenimiento

6. AVAILABLE ACCESSORIES

Return / Supply side ePM
Made of galvanized steel sheet frame and undulated filter media, 48mm thickness, in white synthetic material, contained by
two welded galvanized nets. The filter media has a low pressure drop and it may be installed as pre-filter in combination with
ePM ≥ 80% (F9) filters, located on the room air return side and/or supply air side.
1
Return side ePM ≥ 50% (F7) air filter
1
Built with a polyester frame and a rigid bag filter media, tickness 292 mm, made of white glass microfibre. The filter media
has an ePM ≥ 50% (F7) filtering degree, according to ISO 16890 and has a large filtering surface area that guarantees long
1
operating life and less frequent replacements.
Supply side ePM ≥ 50% (F7) air filter
1
Built with a polyester frame and a rigid bag filter media, tickness 292 mm, made of white glass microfibre. The filter media
has an ePM ≥ 50% (F7) filtering degree, according to ISO 16890 and has a large filtering surface area that guarantees long
1
operating life and less frequent replacements.
Return side ePM ≥ 80% (F9) air filter
1
Built with a polyester frame and a rigid bag filter media, tickness 292 mm, made of white glass microfibre. The filter media
has an ePM ≥ 80% (F9) filtering degree, according to ISO 16890 and has a large filtering surface area that guarantees long
1
operating life and less frequent replacements.
Supply side ePM ≥ 80% (F9) air filter
1
Built with a polyester frame and a rigid bag filter media, tickness 292 mm, made of white glass microfibre. The filter media
has an ePM ≥ 80% (F9) filtering degree, according to ISO 16890 and has a large filtering surface area that guarantees long
1
operating life and less frequent replacements.
Water control valve
It consists of a kit including the 3-way valve for the control of the water flow, to be combined with the hot and/or cold water
coil, and its modulating electric actuator. Connection and fitting devices not included (to be arrange for by the installer).
Hot water coil (internal)
The hot water coil is manufactured with copper pipes thickness 0,4 mm and aluminium fins thickness 0,11 mm. The pipes are
mechanically expanded in the aluminium fins to increase the thermal exchange rate. On request, it is possible to install coils
with different capacities from the standard ones, when previously agreed with the factory.
Cold water coil (internal)
The coil is manufactured with copper pipes thickness 0,40 mm and aluminium fins thickness 0,11 mm. The pipes are
mechanically expanded in the aluminium fins to increase the thermal exchange rate. On request, it is possible to install coils
with thermal performances different from the standard ones, when previously agreed with the factory. The cooling coil
section is supplied complete with condensate drain pan with water discharge.
≥ 50% (F7) air pre-filter
1
EN
16