Receipt And Inspection; Storage; Unpacking - Casals QUANTICA EEC Manual De Instalación, Operación Y Mantenimiento

Idiomas disponibles

13.1 Receipt and inspection

When installing or working on the unit, it is necessary to scrupulously follow the instructions given in this manual, observe the

indications on board the unit and in any case apply all necessary precautions. Failure to follow these instructions may result

in dangerous situations.

Upon receipt of the unit, check its integrity: the machine left the factory in perfect condition; any damage must be immedi-

ately reported to the carrier and noted on the Delivery Note before signing it.

The Company must be informed, within 8 days, about the extent of the damage. The Client must fill out a written report in

case of significant damage.

Before accepting the delivery check:

• that the unit has not been damaged during transport;

• that the material delivered corresponds to what is indicated in the transport document.

In case of damages or anomalies:

• immediately note the damage on the Delivery Note;

• inform the supplier, within 8 days of receipt, of the extent of the damage. Reports made after this deadline are not valid;

• in the event of significant damage, file a written report.

If it is necessary to store the unit, leave it packed in a closed place. If for some reason the machine has already been unpacked,

follow the instructions below to prevent damage, corrosion and/or deterioration:

• make sure all openings are properly plugged or sealed;

• do not use steam or other cleaning agents to clean the unit, as these may damage it;

• remove any keys used to access the control panel and give them to the site manager.

Packaging material (plastic film, expanded polystyrene, etc.) must be kept out of the reach of children as a

potential hazard.

It is advisable to leave the units packed during handling and to remove the packaging only at the time of installation. Remove the

packaging of the unit with care to avoid possible damage to the machine.

The materials making up the packaging can be of different kinds (wood, cardboard, nylon, etc.). It is advisable to remove the

protective film from the panels (if present) after the installation of the unit.

Packaging materials should be stored separately and handed over for disposal or recycling to the appropriate.

Tabla de Contenido