Publicidad
Idiomas disponibles
Idiomas disponibles
Under extreme conditions, battery leakage may occur. When you notice
liquid in the battery, proceed as follows:
ES
Carefully wipe off the liquid with a cloth. Avoid contact with skin.
In case of contact with skin or eyes, follow the instructions below:
1. Rinse immediately with water. neutralize with an acid
PT
mild as lemon juice or vinegar.
2. In case of contact with eyes, rinse thoroughly with
clean water for at least 10 minutes.
EN
3. Consult a doctor.
Fire danger! Avoid shorting the contacts of a battery. Do not
incinerate the battery.
FR
CHARGERS
• Never try to charge non-rechargeable batteries.
• Replace defective cables immediately.
• Do not expose to water.
• Do not open the charger.
• Don't test the charger.
• The charger is designed for indoor use only.
OPERATION
BEFORE USING THE EQUIPMENT:CARGADOR DE BATERÍA
The lithium ion battery can be charged at any time and will not develop
a "memory" when charged after partial discharge. It is not necessary
to deplete the battery charge before recharging it. Remove the battery
pack from the tool when it is convenient for you and your work. You can
"top off" your battery pack before starting a big job or a long period
of use. Due to the non-fading properties of lithium-ion, the only time
the lithium-ion battery pack needs to be charged is when the pack has
reached the end of its charge. To signal the end of charging, the power
to the tool will rapidly reduce. Charge the battery as needed.
CHARGING THE BATTERY
This lithium-ion battery pack ships partially charged. Before using it for
the first time, fully charge the battery. A fully discharged 2.0Ah battery
with a temperature between 4 C and 40 C will charge in approximately
1 hour.
Plug the charger adapter into the power source. The green light on the
charger cradle will illuminate, indicating that the charger is on.
Slide the battery all the way into the charger mount. The red light on
the charger cradle will illuminate, indicating the battery is charging.
The red light will turn off after charging is complete and a green light
will appear.
NOTE: Batteries can become hot during charging. This is
Instruction manual
normal. If the battery is hot after continuous use on the tool, allow
it to cool to room temperature before charging. This will extend the
life of your batteries.
before making any assembly or changing accessories.
RECHARGEABLE BATTERY INSERTION AND REMOVAL
• Press the battery release button located on the front of the
adjustments to the equipment. Be sure to read the following
information before operating your wireless equipment: Charge the
battery with the charger. An empty battery requires a charging
period of approximately 0.5 to 1 hour.
FUNCTIONS
• Insertion and removal of rechargeable battery.
• Press the battery release button located on the front of the
• Pull out the battery and remove it from the tool.
adjustments to the equipment.
Be sure to read the following information before operating your wireless
equipment: Charge the battery with the charger. An empty battery
requires a charging period of approximately 0.5 to 1 hour.
WARNING: Always disconnect the battery pack from the tool
battery pack to release the battery pack. Pull out the battery and
remove it from the tool.
WARNING: Always remove the battery before making any
battery pack to release the battery pack.
WARNING: Always remove the battery before making any
08769
REF.
Publicidad
