module can fall off. Remove oil and grease from the adapter and from the outside surfaces of the tool
holder with a cloth.
▶ Make sure that the module does not get too hot. The material will melt at temperatures above 80 °C.
▶ Do not use the module as a grip for carrying or guiding the system. The power tool has grips designed
for this purpose; use these grips.
▶ When the power tool is in operation, do not hold it by the suction head.
3
Description
3.1
Product overview
3.2
Intended use
The product described is a dust removal module that is used as an accessory in combination with Hilti
breakers and dust extractors.
3.3
Items supplied
Suction base, toggle lever, S adapter, Y adapter, suction head short, suction head long, operating instructions
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
4
Technical data
Weight
Dimensions (L × W × H)
Tool type
Length of drill bit / chisel
Ambient temperature for operation
Storage temperature
5
Operation
5.1
Fitting the dust removal module
The exposed length of the accessory tool projecting from the suction head must be no more than 125
mm and no less than 30 mm. This will ensure optimum dust extraction.
Use only the pointed chisels, flat chisels and bushing tools shown in Fig. 2.
When installing, make sure that there is no accessory tool inserted in the power tool.
1. Select the appropriate adapter and push the adapter all the way on to the tool holder.
2. Open the toggle lever on the suction base.
3. Push the suction base, with the toggle lever open, all the way on to the adapter.
8
English
1
Suction head, long
≤ 590 g
340 mm × 152 mm × 98 mm
Pointed chisels, flat chisels,
bushing tools
400 mm ... 500 mm
−17 ℃ ... 60 ℃
−20 ℃ ... 70 ℃
2
Suction base
@
Toggle lever
;
Y adapter
=
S adapter
%
Suction head, short
&
Suction head, long
(
Suction head, short
≤ 440 g
201 mm × 152 mm × 98 mm
Pointed chisels, flat chisels,
bushing tools
290 mm ... 390 mm
−17 ℃ ... 60 ℃
−20 ℃ ... 70 ℃
249449
*249449*