Care And Service; Optional Accessories; Troubleshooting Guide; Technical Data - Kärcher WD 2 Plus Manual

Interrupting operation
1. Set the trigger to "0 OFF".
The device is switched off.
2. Variant 1: Place the handle of the suction hose in the
intermediate parking position.
Illustration O
Variant 2: Attach the floor nozzle in the parking po-
sition.
Illustration P
Ending operation
1. Set the trigger to "0 OFF".
The device is switched off.
2. Pull out the mains plug.
3. Remove the device head.
Illustration B
4. Empty the container.
Illustration Q
5. Storage possibility:
Illustration T
Note
The suction hose can be wrapped around the device
head and attached to the device head with the help of
the hose collar.
6. Store the device in a dry and frost-proof room.

Care and service

General care instructions
 Clean the device and plastic accessory parts with a
commonly available plastic cleaner.
 Rinse the container and accessories with water, as
necessary, and dry them before further use.
Clean the foam filter / cartridge filter
1. If necessary, the foam filter / cartridge filter can be
cleaned under running water. To do this, remove the
foam filter from the filter basket. The cartridge filter
can be unlocked and removed by turning it towards
the symbol .
2. Do not rub or scrub the foam filter / cartridge filter
when cleaning it.
3. Allow the foam filter / cartridge filter to dry complete-
ly before using it again.
4. Depending on the filter type, reinsert as follows:
 Foam filter: Pull the filter over the filter basket and
ensure that it is fixed correctly.
 Cartridge filter: Install the filter on the filter basket,
turn it towards the symbol
is fixed correctly.
Illustration R
Illustration S

Optional accessories

Note
For variants with a foam filter, a cartridge filter can be
purchased later as a special accessory and used in-
stead of the foam filter.
1. Before inserting the cartridge filter, remove the black
cover cap and keep it with the foam filter for later
use.
2. Put on the cartridge filter and screw it tight.
Illustration R

12
Malfunctions often have simple causes that you can
remedy yourself using the following overview. When in
doubt, or in the case of malfunctions not mentioned
here, please contact your authorised Customer Service.
Declining suction performance
Accessories, the suction hose or the suction tubes are
clogged.
 Remove the clog with a suitable aid.
The filter bag is full.
 Replace the filter bag.
The foam filter / cartridge filter is dirty.
 Clean the foam filter / cartridge filter (see chapter
The foam filter / cartridge filter is damaged.
 Replace the foam filter / cartridge filter.
Note
The technical data can be found on the type plate.
and ensure that it
English

Troubleshooting guide

Clean the foam filter / cartridge filter).

Technical data