Water Softener Installation - Osmofilter TM68 Manual De Usuario

06.

WATER SOFTENER INSTALLATION

Installation of this dishwasher is to be performed by authorized service and following the instructions
that the country's legislation.
Then follow the steps below for proper installation:
1. Check the water pressure of the network: it must be at least 2.5 bar and maximum 6 bar. Remember that
water temperature must be between 5 ° C and 40 ° C.
2. Before the installation, close the water tap usually the same place you are going to install and open a
faucet to depressurize it.
3. Choose an installation location near an electrical outlet of 220V - 50Hz
4. Check the correct status of the tubes.
5. Remove the cap covering the valve and then the lid of your softener. Remove the by-pass valve and the
transformer:
6. Connect the inlet and outlet to the "By-Pass".
3
1 2
7. Follow these steps to put the by-pass valve:
Remove the clips Remove the threads
on the threads. Input / Output.
8. Check the volumetric counter sensor is connected properly.
1. Input connection
2. Outlet connection
3. Drain connection
Place the boards
both threads.
SENSOR
1
1 2
Place the threads
in the valve.
2
1. Input connection
2. Outlet connection
Re-placing
Insert the By-pass
the clamps
in the valve.