Publicidad
Idiomas disponibles
Idiomas disponibles
makes contact with the adjusting hex bolt of
the stopper block.
Setting of the upper limit
The upper limit of the tool body can be adjusted
by turning the nylon nut.
Do not lower the upper limit nut too low.
The bit will protrude dangerously.
Adjustment using the revolver- depth stop
Fig. A + E
The revolver-depth stop enables you to quickly
choose between three different cutting depths.
These are also determined by the adjustment of
the depth stop (10).
For larger routing depths, it is recommended to
carry out several repetitive cuts with lower
removal rates.
•
Adjust the required cutting depth by rotating
the revolver-depth stop (21).
5. MAINTENANCE
Make sure that the machine is not live
when carrying out maintenance work on
the motor.
These machines have been designed to operate
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper machine care and regular
cleaning.
Cleaning
Regularly clean the machine housing with a soft
cloth, preferably after each use. Keep the
ventilation slots free from dust and dirt. If the dirt
does not come off use a soft cloth moistened with
soapy water. Never use solvents such as petrol,
alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
Troubleshooting
Please find some potential causes and solutions
to possible failure.
1 The operating switch is switched on, but
the motor is not working
•
The electric circuit is broken
• Have the electric circuit repaired
•
Wires in the mains plug or in the socket are loose
• Have socket and plug checked or repaired
•
The switch is faulty
• Have the switch repaired
2 Router runs slowly
•
Blunt or damaged cutter
• Re-sharpen or replace cutter
•
Variable speed set low
• Increas variable speed
•
Motor is overloaded
• Reduce pushing force on router
3 Excessive vibration
•
Bent cutter shank
• Replace cutter
4 Sparks inside the housing
•
Carbon brushes are worn
• Replace the carbon brushes
Faults
Should a fault occur, e.g. after wear of a part,
please contact the adress on the warranty card.
Included you find an exploded view showing the
parts that can be ordered.
ENVIRONMENT
In order to prevent the machine from damage
during transport, it is delivered in a sturdy
packaging. Most of the packaging materials can
be recycled. Take these materials to the
appropriate recycling locations.
Faulty and/or discarded electrical or
electronic apparatus have to be collected
at the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EU
for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
friendly way.
WARRANTY
The guarantee conditions can be found on the
separately enclosed guarantee card.
The product and the user manual are subject to
change. Specifications can be changed without
further notice.
7
Publicidad
