Publicidad
Idiomas disponibles
Idiomas disponibles
4.
When product working, press the "Timer " on control panel or remote control,
.the indicator light of timer turn on, LED will display : 00-01-02....11-12-00. "00"
means cancel the timer, "01-12" means setting for 1 to 12 hours. After setting, the
LED display will flash for about 3 seconds.
If cancel the timer, LED will display room temperature, and the indicator light of
timer will be off. If set timer, LED will display room temperature, and the indicator
light of timer will be on.
After timing reach, product stop heating. After blow about 15 seconds, louver
close. Product standby. At the work of timing, Press "Timer" for once, it will show
the rest time for off. Press "Timer" for more than once, it will set again for timing.
5. When product working, press the "Temperature " on control panel or remote
control, .the indicator light of temperature turn on, LED will display : 00-20-21....29-
30-00. "00" means cancel the temperature, "21-30" means setting for 21 to 30
temperature. After setting, the LED display will flash for about 3 seconds.
If cancel the temperature, LED will display room temperature, and the indicator
light of temperature will be off. If set temperature, LED will display room
temperature, and the indicator light of temperature will be on.
After temperature reach, the product will stop heating and blow for 15 seconds.
Other indicator light is still on. If set timer before, it still works. When room
temperature is 2 more degree lower than setting temperature, product will start
heating. At the work of temperature, press "Temperature" for once, it will show the
setting temperature.
Press "Temperature" for more than once, it will set again for temperature.
1. Connect to any 220-240V, 50Hz, AC source. Press
the Power switch at back side, the heater standby,
LED will display room temperature, then please use
remote control or button on control panel to operate.
2. Press the "ON/OFF Heat" button on control panel
of the heater for once or press the "ON/OFF" button
on remote control, the indicator heat light will turn to
blue, and blow the low heating wind.
Then, Press the "ON/OFF Heat" button on control
panel of the heater for twice, or press the "Heat"
button on remote control, the indicator heat light will
turn to green, and blow the high heating wind.
Then, Press the "ON/OFF Heat" button on control
panel of the heater for third time, or press the
"ON/OFF" button on remote control, it will stop
heating. After blow about 15 seconds, louver close.
Product standby.
3. When product working, press the "Swing" button on
the control panel or remote control for once, the
indicator light of swing turn on, product swing for
blowing. Press the button for twice, the indicator light
of swing turn off, product stop swing.
5
Publicidad
