Ketra D3 Serie Guia De Instalacion página 8

I N S TA L L AT I O N
3. Optional: If installing a square fixture, loosen the collar's two outer screws, freeing the collar for
rotation, which then can be aligned to the fixtures per design.
a. Realign the collar using its v-shaped notches and an alignment string or laser.
b. Re-tighten the screws to lock the collar's new position.
Option 2
M O U N T I N G W I T H B U T T E R F LY B R AC K E T S
1. Reposition emitter chassis
a. Remove the cardboard plug from the D3's aperture.
b. Carefully remove the optic by turning counter-clockwise and pulling.
Note: Demonstrate caution when removing wall wash optic due to possible damage.
Note: If you remove the optic, be careful not to touch the exposed silicone dome on the
emitter.
c. Unlock the tilt lock by pulling it toward the fixture aperture. The tilt lock is the red, horizontal lever
to the right or left side of the emitter chassis body (see fig. 5).
d. Unlock the rotation lock by pulling it toward the fixture aperture. The rotation lock is the red,
vertical lever across from the emitter chassis body (see fig. 6).
e. Tilt and rotate the emitter chassis to open an unobstructed path to the butterfly bracket openings
Rotation Lock and Release
on either side of the housing.
Unlocked Locked
fig. 5
8 | D3 INSTALLATION GUIDE
Unlocked
fig. 6
© 2019-2022 Ketra, Inc. All rights reserved.
P/N 3662708 Rev A