Publicidad
Idiomas disponibles
Idiomas disponibles
25
Figure 6
(Actual probe may be different with the probe as Figure 6, please accept the actual probe with the
device)
Fingernails and the luminescent tube should be at the same side.
In the process of using the tested finger had better not shake, the human body also had
better not be in motion state.
B. Long press the "power on/off " button, until the device turns on.
C. Do not shake the finger and keep the user in a stable state during the process.
D. The data can be read directly from the screen in the measure interface.
5.2 Pause sound prompt
A. Sound prompt, including: over-limit, low-battery and probe or finger out.
B. Under the measurement interface, turn on the sound prompt, when the sound prompt occurs, short
press the button to pause the sound prompt, and it will resume automatically after about 60s.
C. If you want to turn off the sound prompt permanently, please set it in menu.
5.3 Review Interface
A. In the measure interface,press "up button" to enter the Review Interface 1 directly, as shown in Fig-
ure 7:
Figure 7-1. Review Interface 1
B. In review interface, press "menu button" to switch between Review Interface 1 and Review Interface
2.
C. In Review Interface 1,the user can observe the trend waveform composed by storage data.Each
screen can show storage data for 105 seconds.The yellow line shows the SpO2 trend waveform,and
the red line shows the PR trend waveform.The time underside shows the starting time of displaying
the date in the screen, the middle "+" and "-" at the underside of the screen means the operation
direction of the "Down button". Press "right button", it will show "+" in the position, then press "Down
ENGLISH
Figure 7-2. Review Interface 2
Publicidad
