MSW -MS-65 Manual De Instrucciones página 29

j) Turn the guide from one side to other, blocking it and pressing on it slightly
with finger (figure 1f).
k) Remove the drill bit and the mounting and turn it (1g). Repeat step k).
l) Check with the help of the wedge provided on the attachment that both edges
of the flank on the drill bit are evenly sharpened. They should meet exactly in
the middle, as in figure 1h. Figure 1i shows how it should not look.
m) After completing the sharpening and if the device is no longer used switch it
off with the ON/OFF button (A). Wait until the whetstone stops before
removing the attachment.
3.3.2 Sharpening knives/scissors
Sharpening knives:
CAUTION: The device enables sharpening only flat-blade knives - do not use for
serrated blades, etc.
a) Fit the appropriate knife/scissor sharpening attachment (C) on the device.
b) Switch the device with the ON/OFF button (A).
c) Grasp the knife to be sharpened firmly by the handle and insert the grind of
the cutting edge of the blade into the knife sharpening groove (see figure 2a).
d) Pull the cutting edge on the whetstone from the handle to the tip, applying a
constant, light pressure – do not press too hard (figure 2b)! Then remove the
knife from the groove.
e) Place other side of the cutting edge into the knife sharpening groove (figure
2c) and repeat the action from point d).
f) Repeat the sharpening of each side of the cutting edge's sides until even, sharp
blade is obtained.
g) After completing the sharpening and if the device is no longer used switch it
off with the ON/OFF button. Wait until the whetstone stops before removing
the attachment.
Sharpening of scissors