Lower Clamp - Large Part #579; Qty. 2; Rubber Pad; Part #720035 - Bestop 77309 Instrucciones De Instalación

Section 4 Install Rubber Pads; Attach Lower Clamps
Attach two (2) Rubber Pads together, and stick
them to the Rear Rail Clamp,
between the rib farthest from the rail, and the
next rib.
NOTE : The Rubber Pads must rest on top
of the bed rail cap after installation.
The Rear Clamps should be located 10.0" from
the end of each Rear Side Rail.
P8 - 77309 Rev. H 0922
10.0"
Ó 5 7 9 .
Hex Head Bolt
Part #578.39
Qty. 4
Installation Instructions - Supertop for Trucks
Parts

Rubber Pad

Part #720035

Qty. 4
9/16" Wrench
Lower Clamp -
Large
Part #579.23

Qty. 2

Lower Clamp -
Small
Part #595.34
Qty. 2
Page 8
Attach Large Lower Clamps to the rear
pre-assembled Upper Clamps on the
Side Rails, using one (1) Hex Head Bolt
for each clamp.
Attach Small Lower Clamps to the front
pre-assembled Upper Clamps on the
Side Rails, using one (1) Hex Head Bolt
for each clamp.
Check alignment of the Rail Assembly
and tighten all bolts.
Tighten all bolts to 55 in-lbs torque.
© 2020 Bestop, Inc.