Error Codes - Gude GRR 180.1 Traducción Del Manual Original

Lift sensor
This sensor checks whether the wheels are in contact with the ground. If the robot lawnmower is lifted or if the
wheels run free, the robot switches off and must be restarted manually.
Tilt sensor
The robot lawnmower has an integrated 6-axis sensor that measures the tilt angle in all directions. If the tilt angle
exceeds 30°, the cutting motor stops immediately, but the mower continues to move. If the angle drops to less than
30° within 10 seconds, the cutting motor restarts automatically. However, if the angle does not decrease within 10
seconds, the mower will shut down and require a manual restart.

Error codes

Error codes: are shown on the LCD display
Caution: Manual restart - Place the unit within 1 metre of the boundary line, enter the correct PIN and press „Start".
Error code Causes
E1 Stop button has been activated.
E2 Lift sensor has triggered.
E3 Robot is outside the boundary lines.
E4 No boundary line signal.
E5 A collision sensor was triggered.
E6 Overload on the left drive motor.
E7 Overload on the right drive motor.
E8 Overload on the cutter motor.
E9 Battery is defective
E10 Undervoltage of the battery detected.
E11 Tilt sensor triggered
E12 Wheel turns without stop/grip.
E13 Battery has overheated.
Removal
Restart the robot.
Has the robot been lifted? Wheels blocked?
If necessary, remove foreign objects and restart the
robot manually.
Position the robot within the boundary lines and
restart it manually.
Check the status LED of the charging station. If the
LED flashes red, the boundary line is broken or the
boundary wire is not connected to the station.
Check connection
Remove all obstacles or reposition the robot and
restart it.
Grass is too high or dense? Wheels blocked?
If the grass is higher than 2.6 inches/ 6.6 cm, please
mow with traditional lawn mower. If the grass is
lower than 2.6 inches, please adjust the height on
the robot so that it works unhindered.
Grass is too high or dense? Wheels blocked?
If the grass is higher than 2.6 inches/ 6.6 cm, please
mow with traditional lawn mower. If the grass is
lower than 2.6 inches, please adjust the height on
the robot so that it works unhindered.
Grass is too high or dense? Wheels blocked?
If the grass is higher than 2.6 inches/ 6.6 cm, please
mow with traditional lawn mower. If the grass is
lower than 2.6 inches, please adjust the height on
the robot so that it works unhindered.
Contact the service department.
Position the robot at the charging station and
restart it manually. If the problem persists, please
contact the service department.
Incline angle greater than 30 degrees? Robot has
turned upside down?
Place the robot on a flat, level surface and restart it.
All wheels must touch the ground for this.
Is the robot stuck in the sand or in a hole?
Check the lawn area. Place the robot on a flat, level
surface and restart it.
Let it cool down, otherwise contact the service
department.
ENGLISH
37