Unpacking And Checking Carton Contents; Assembly - Vacmaster VZA0708P Manual De Instrucciones

GB
UNPACKING AND CHECKING CARTON
1 Power Head
2 Latch
3 Rear Wheel
4 Front Caster
5 Suction Inlet Port
6 Collection Tank
7 On/Off Switch
8 Cable Rewind
1. Remove all the contents from inside of the vacuum cleaner collection tank.
2. Remove the pre-installed pre-filter, and fully fit the dust bag flange onto the inlet stub
(Fig. 1). Place the pre-filter back into the container (Fig. 2).
NOTE:
Ensure the bag and filter are always fitted before use.
3. Fit the power head back onto the collection tank by securing the two latches (Fig. 3). Ensure
the power head sits properly on the collection tank and is correctly sealed.
4. Attach the locking end of the hose into the suction port of the container and turn clockwise to
tighten (Fig. 4).
5. Choose the desired accessories and/or extension wands and push and twist onto the hose
nozzle (Fig. 5).
CONTENTS
9 Carry Handle
10 Exhaust Filter Cover
11 Floor Nozzle Storage
12 Accessory Storage
13 Power Cable
14 Suction Hose
15 Floor Nozzle
16 Dust Bag (x5)

ASSEMBLY

10
17 Crevice Tool
18 Round Dusting Brush
19 Pre-filter (pre-installed)
20 Extension Wand (x2)
21 Exhaust Filter (pre-installed)
22 Instruction Manual