Manual Defrost; Cleaning, Care & Maintenance - Polar UA022 Manual De Instrucciones

EN
Installation
Note: Not for use in vans or trailers, food
trucks or similar vehicles.
Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging and
the protective film from all surfaces.
2. Avoid positioning the appliance in direct
sunlight or damp areas.
3. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 5cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
4. Insert the slide-out shelf/shelves at the desired
levels and place the smaller shelf/shelves on
the floor of the appliance.
5. If necessary, adjust the screw feet of the
appliance to make it level.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water.
Operation
Control Panel
B A
A - Power Switch
B - Light Switch
4
UA022_ML_A5_v1_20220425.indb 4 UA022_ML_A5_v1_20220425.indb 4
Turn On
1. Close the doors of the appliance.
2. Switch on the Power Switch [I]. The current
temperature within the appliance is displayed.
3. Turn the light switch On [I] or Off [O] as
desired.
Note: The Cooling Light is
illuminated when the appliance
is chilling the interior cabinet.
Set the Operating Temperature
1. Hold the SET button for 3 seconds. The value
of the current set point will be displayed.
2. Press the or buttons to display the
required temperature.
3. Press the SET button to store the temperature.

Manual Defrost

• POLAR Back Bar Coolers feature an automatic
defrost. However, should the appliance require
an additional defrost period press and hold the
"aux" button for 6 seconds.
• Automatic defrost cycles are every 6 hours and
last 20 minutes (factory defaults).
• To stop the Defrost press and hold the"aux"
button for 6 seconds.
Note: If a manual defrost is
started this resets the automatic
defrost timer. During defrost
periods the Defrost light is
illuminated.
Cleaning, Care &
Maintenance
Switch off and disconnect
from the power supply before
cleaning.
• Clean the interior of the appliance as often as
possible.
• Do not use abrasive cleaning agents. These
can leave harmful residues.
• Always wipe dry after cleaning.
2022/4/25 09:55 2022/4/25 09:55