Installation; Suspension From The Ceiling; Suspension From Wall (Sop. Cor-Pro Accessory) - S&P COR-PRO W Manual Del Usuario

7. INSTALLATION

Ceiling anchoring by threaded rods (not included)

COR-PRO W units can be installed from ceiling by four suspension points (ﬁ ve for 2500 length model). Suspension points

are accessible from the outside. Anchorage type is by means os M10 riveted nuts.

Once installed, verify that unit is installed horizontally

in all directions. If it is necessary to reduce vibrations

created by clamping structure type, use anti-vibration

mounts. Finally, remember that unit must always hold

on all suspension points.

Only use appropiate anchors and dowels. Carefully analize lo-

cations of the installation and the suitability of the anchors and

fasteners used, as well as the strength of the structure. Always

keep in mind the ceiling and wall capacity. Unit must only be

mounted on a stable beam. The manufacturer is not responsi-

ble for failures caused by improper use of pins, fasteners and/

or suspension material.

COR-PRO W air curtains can also be wall-mounted using factory

default M10 metric anchors points. The SOP. COR-PRO accessory

facilitates this installation by incoporating following components:

4 x M10x30 allen screws, 4 x M10 rigid washers and 4 x M10 spring

washers. The corresponding accessory for 2500 model length is

SOP. COR-PRO 2500. It consist in an additional central support.

Measure the position of air curtain and mounting wall. Mark the anchor points and drill holes in the wall to place an-

chors (not included). Attach the wall mount hanger to the wall with an appropriate mounting material (not included).

Finally, attach the wall mount hanger to the air curtain using included allen screws and washers. Pay attention when

tightening all the screws as well as the important ﬁ xing material.

Use only appropriate anchors and dowels. Carefully analyse the location of the installation and the suitability

of the anchors and fasteners used, as well as the strength of the structure. The manufacturer is not respon-

sible for failures caused by improper use of the pins, fasteners and / or suspension material.

Wall anchorage by SOP. COR-PRO accessory

Minimum

distance of

installation

Tabla de Contenido