Assembly; Storing The Torx Wrench; Attaching The Miter Lock Knob - Bosch GCM18V-10SD Instrucciones De Funcionamiento Y Seguridad

Ocultar thumbs Ver también para GCM18V-10SD:

Idiomas disponibles

To avoid possible injury, disconnect battery pack before performing any as-

sembly, adjustments or repairs.

There is a storage location on the saw to store

the Torx wrench (Fig. 7, 41). Insert the short leg

of the Torx wrench through the rubber grommet

as shown. Place the long leg into the tool rest.

NOTE: The

Torx wrench (41) is needed to

change the blade and to attach the side exten-

sions. If lost, use a Torx 30 wrench or a key.

Fig. 7

16099221PJ GCM18V-10SD OSI 20220506.indd 18

Assembly

1. Locate the miter lock knob (20) from among

the loose parts.

2. Look under the turntable's front arm, below

the miter detent override button (Fig. 8, 21),

and locate the 10mm hole.

Fig. 8

3. Insert the long shaft of the miter lock knob

through this hole until it stops.

4. Turn the knob clockwise (about 8 full revolu-

tions) until it is tight or "locked."

5. Loosen the knob 1/2 turn to unlock it. The

table is now free to be moved on the base.

-18-

5/6/22 11:42 AM

Tabla de Contenido