sunjoe 24V-CTC-CT Manual Del Operador página 7

Fig. 1
Push lock button
2. Depending on your Snow Joe
how to recharge your lithium-ion battery will vary. You may
either insert your 24-volt battery into the 24VCHRG-QC
Quick Charger (sold separately) or the 24VCHRG-DPC
Dual-Port Charger (sold separately) (Figs. 2 – 3).
Fig. 2
Charging
red
24VCHRG-QC
Quick Charger
(sold separately)
Fully
Charged
green
Fig. 3
Charging
red
Fully
Charged
green
® + Sun Joe ® charger model,
Battery pack
Battery pack
24VCHRG-DPC
Dual Port Charger
(sold separately)
1. The battery indicator LEDs will illuminate one by one during
the charging process. Unplug the charger immediately
when the 3 LEDs are all illuminated.
2. The 24VCHRG-QC Quick Charger (sold separately) and the
24VCHRG-DPC Dual-Port Charger (sold separately) are also
equipped with additional charging indicating lights that will
indicate the charging status (Figs. 2 – 3).
m
CAUTION!
FIRE HAZARD. When disconnecting the
charger from the battery, be sure to unplug the charger from the
outlet first, then disconnect the charger from the battery.
m
WARNING!
This charger does not automatically turn off
when the battery is fully charged. Please take care not to leave
the battery plugged into the charger. Switch off or unplug the
charger at the mains when charging is complete.
3. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when you
notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged, as this will cause irreversible damage to the battery.
4. When charging is complete, remove the battery from the
charger by pulling the push lock button and sliding the
battery backward to unlock it from the charger.
Assembly
m
WARNING!
Do not insert the battery until assembly is
complete. Failure to comply could result in accidental starting
and serious personal injury.
m
WARNING!
The product must be fully assembled before
operation. Do not use a product that is only partially assembled
or assembled with damaged parts.
Follow the assembly instructions step-by-step and use the
figures provided as a visual guide to assemble the product.
Sweeper Head Assembly
1. Snap the guard onto the sweeper head, then secure using
the two included thread forming screws (Fig. 4).
Fig. 4
7
Guard
Thread
forming
screw