Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARING FOR USE
Exhausting hot air
The appliance must be placed close to a window or opening so
that the warm exhaust air can be ducted outside.
First position unit on a levelled floor and make sure there's a
minimum of 30 cm clearance around the unit, and is within the
vicinity of a single circuit outlet power source.
1. Extend either side of the hose(Fig.1) and screw the hase
to hase outlet (Fig.2).
2. Extend the other side of the hase and screw it to hase
inlet (Fig.3).
3. lnstall the hase in let into the unit(Fig.4 ).
4. Affix the hase outlet into the window slider kit and seal.
(Fig.5&6)
Vertical
• •
window
Extend or eut the window
slider kit to fit the window.
Fig.5
+
Horizontal
window
0
Extend or eut the window
slider kit to fit the window.
Fig.6
The hase can be extended from its original
length, but it is the best to keep the length
to minimum required. Also make sure that
the hase dose not have any sharp bends or
sags. (Fig.7).
60
Extend the side of hose
Fig.2
r@�� - 0
Fig.3
i
ff
[ [ [ [[[( ( ( ( ( ( ( ( ( ( ( [ [ [ ( [[ [ [ [ fü ()
..
Fig.4
Fig.7
Publicidad
