Operation - Craftsman 247.29930 Manual Del Operador

Fuel Cap
Muffler
Air Filter
Choke
Throttle
Pull Starter Handle
Now that you have set up your tiller for operation, get aquainted with its
controls and features. These are described on the next two pages and
illustrated on this page. This knowledge will allow you to use your new
equipment to its fullest potential.
reCoIl StArter hANdle
This handle is used to start the engine. See Figure 5.
throttle CoNtrol
The throttle control is located on the front of the engine. It regulates the
spread of the engine and will shut off the engine when moved into the
STOP position. See Figure 5.
Craftsman Tillers conform to the safety standard of the American National Standards Institute (ANSI).

OPERATION

Reverse Handle
Oil Fill Cap
& Dipstick
Oil Drain
Figure 5
Choke CoNtrol
The choke control is found on the rear of the engine and is activated
by moving the lever to the CHOKE position. Activating the choke
control closes the choke plate on the carburetor and aids in starting the
engine. See Figure 5.
Meets ANSI Safety Standards
10
Depth Regulator
Handle Height
Adjustment
Side Shield
Tines
Wheel Drive Pin
WArNING
The operation of any tiller can result in foreign objects being thrown
into the eyes, which can damage your eyes severely. Always wear
safety glasses during operation or while performing any adjustments
or repairs.
Forward Clutch Bail
& Tine Engagement
Rear Tine Shield