Kalor Redonda Glass Manual De Instrucciones página 101

In the automatic
position the
thermostove always
runs at full power
The thermostove starts
up "alone"
The power does not
change even if you
manually adjust
Anomalies related to the plumbing circuit
PROBLEM
No increase in
temperature with
Thermostove in
operation
Condensation
in thermostove
Radiators cold in winter
but the thermostove
boils
Hot water in not
provided
1. Room thermostat
maximum
2. Temperature sensor defective
3. Control panel defective or
broken
1. Incorrect programming of the
cronothermostat
1. The board is set to automatic
correction of power in proportion
to the temperature
POSSIBLE CAUSE
1. Incorrect combustion
adjustment
2. Thermostove/system dirty
3. Insufficient Thermostove power
1. Incorrect setting maximum
water temperature in the
thermostove
2. Insufficient fuel consumtion
1. Circulator does not run because
blocked
2. Radiators have air in them
1. Circulator pump blocked
set to
1. Reset the thermostat temperature
2. Check the operation of the sensor and replace if
necessary
3. Check the panel and replace if necessary
1. Check the settings of the cronothermostat
1. Contact your Authorized Assistance Center
REMEDY
1. Check parameters
2. Check and clear the thermostove
3. Check that the Thermostove is properly sized for the
requirements of the system
1. Set the Thermostove to a higher temperature. The
maximum water temperature in the thermostove is 65
° C and can not be set below 40 ° C or above 80 ° C.
It is advisable to never adjust the temperature below
50/55 ° C to avoid condensation in the thermostove.
Adjust the power of the pump at a higher
temperature to 50/55 ° C.
2. Contact your Authorized Assistance Center
1. Free up the circulator by removing the plug and
turning the shaft with a screwdriver.
Check the electrical connections of the same,
replace if necessary
2. Vent the radiators
1. Free the circulator pump
49