BY THE USER
Daily control
The Thermostove requires a simple and thorough
cleaning in order to ensure a more efficient
performance and smooth operation. Clean the
grate using the appropriate tool from the ash and
any incrustation which could obstruct the passage
of air. In the case of depletion of pellets in the tank
may accumulate unburned pellets in the burn pot.
Always empty the residuals from the grate before
each start. Remember that only a brazier located
and clean properly can ensure ignition and optimal
operation of your Thermostove. When positioning
the crucible, carefully check that the ends of the
pads completely adhere to their home and that
the hole with pipe dedicated to the passage of the
resistance. There should be no residual combustion
in the contact zone between the edges of the
crucible and the support surface on the door
crucible.
The decreased or absent cleaning can cause misfire and cause damage to the
thermostove and the environment (possible emissions of soot and unburned). Do not
pour the pellets may be present in the brazier to misfire.
Cleaning exchanger - thermostove off
Fouling act as insulation and the thicker they are,
the lower the heat that is transmitted to the water
and to the structure generally. Therefore very
important to perform the cleaning of the tube
bundle, said exchanger also, to prevent the fouling
of the same and prevent clogging and jamming of
the cleaning device. Pull and push quickly for 5-6
times the lever so that the springs can remove the
soot deposited on the pipes.
Cleaning the steel flame-shell
Every 2-3 days it is important to remove the steel
flame-shell in order to clean it and remove the dirty
that may fall during the cleaning of the exchange
pipes.
39