Kalor Redonda Glass Manual De Instrucciones página 97

Maintenance and cleaning mod. 17
CLEANING BY THE TECHNICAL
Compartment ventilation flue gas cleaning
Remove the fixing screws and remove the smoke fan for cleaning of the same. Perform the task with
the greatest care not to bend the fan blades.
Clean flue
Clean the flue system especially near the fittings to "T", curves and any horizontal sections. Is necessary
to check and remove any deposit of ash and soot before the same clogging the passage of smoke.
Cleaning the heat exchanger
Once a year it is recommended to also clean the
upper compartment of the exchanger. To carry out
a correct cleaning it is recommended to vacuum
the ash, remove all the horizontal joints with a
screwdriver, then vacuum the ash again.
Lift the upper hatch covering the tube bundle by
unscrewing the screws. Remove the 10 springs and
clean the 10 heat exchanger pipes with a brush.
cleaning can be carried out after removing the
springs inserted in each pipe.
The operation is simple by removing the springs
from the horizontal pin to which they are attached.
To perform the operation, the horizontal pin can be
removed through a hole on the wall of the stove
body.
The operation must be completed by unscrewing the
fixing bushings with a screwdriver (photo 1).
Remove the screws that fix the cleaning kit to the machi-
ne body and extract it completely (photo 2 - 3).
Now the upper section of the heat exchanger is
free from any obstruction in order to allow perfect
cleaning.
1 1
3 3
2 2
45