Publicidad
10. Install lanyard using existing self-tapping screw. See Figure 4.
Lanyard
NOTE: Insert self-tapping screw through hole in lanyard and down into
the same hole that it was removed from.
Position Drive Control levers
The drive control levers of the riding mower are lowered for shipping
purposes. Using the hardware found in the manual bag, the control
levers must be repositioned to operate the riding mower. To reposition
the control levers for operation, proceed as follows:
1.
Lift and swing the control levers up into the operating position.
See Fig. 5.
Control Lever Moved
Inward and in Neutral
ASSEMBLY
Existing Self-
tapping Screw
Figure 4
Figure 5
2.
From the outside, insert the bolts through the hourglass spacers
and the holes of the pivot bracket. Secure with the flange lock
nuts. See Figure 6.
Bolt
3.
Refer to "Adjusting the Drive Control Levers" in the Service and Mainte-
nance section for instructions on the final adjustment of the levers.
Connecting the Battery Cables
Battery posts, terminals, and related accessories contain lead and
lead compounds, chemicals known to the State of California to cause
cancer and reproductive harm. Wash hands after handling.
When attaching battery cables, always connect the POSITIVE (Red)
wire to its terminal first, followed by the NEGATIVE (Black) wire.
For shipping reasons, both battery cables on your equipment may
have been left disconnected from the terminals at the factory. To
connect the battery cables, proceed as follows:
NOTE: The positive battery terminal is marked Pos. (+). The negative
battery terminal is marked Neg. (–).
NOTE: If the positive battery cable is already attached, skip ahead to
step 2.
10
Nut
Hourglass
Spacer
Figure 6
WARNING
CAUTION
Publicidad
Solución de problemas
