Publicidad
TRACTOR STORAGE
If your tractor is not going to be operated for an extended period of
time (thirty days to approximately six months), the tractor should be
prepared for storage. Store the tractor in a dry and protected location.
If stored outside, cover the tractor (including the tires) to protect it from
the elements. The procedures outlined below should be performed
whenever the tractor is placed in storage.
1.
Change the engine oil and filter following the instructions provided
in the Service and Maintenance section of this manual..
WARNING
Never store the tractor with fuel in the tank indoors or in poorly
ventilated enclosures, where fuel fumes may reach an open flame,
spark or pilot light as on a furnace, water heater, clothes dryer, etc.
2.
If storing the tractor for 30 days or more:
a.
To prevent gum deposits from forming inside the engine's
carburetor and causing possible malfunction of the engine,
the fuel system must be either completely emptied, or the
gasoline must be treated with a stabilizer to prevent deterio-
ration.
WARNING
Fuel left in the fuel tank deteriorates and will cause serious starting
problems.
b.
Using a fuel stabilizer:
•
Read the product manufacturer's instructions and recom-
mendations.
•
Add to clean, fresh gasoline the correct amount of
stabilizer for the capacity (approximately 3 gallons) of the
fuel system.
•
Fill the fuel tank with treated fuel and run the engine for
2-3 minutes to get stabilized fuel into the carburetor.
c.
Emptying the fuel system:
•
Prior to putting the tractor in storage, monitor fuel
consumption with the goal of running the fuel tank empty.
•
Close the fuel tank shutoff valve. Disconnect the fuel line
from the fuel filter and put the end into an approved fuel
container.
•
Open the fuel tank shutoff valve and drain the fuel tank
and line into the approved container. Reinstall the fuel line
on the carburetor.
•
Start the engine and allow it to run out of fuel. This will
prevent gum and varnish deposits from forming. Replace
the fuel filter.
3.
Remove the spark plugs and pour approximately one ounce of oil
into each cylinder. Crank the engine one or two turns to spread
the oil evenly on the cylinder walls. Replace the spark plugs.
OFF-SEASON STORAGE
WARNING
Never store garden tractor with fuel in tank indoors or in poorly
ventilated areas where fuel fumes may reach an open flame, spark,
or pilot light as on a furnace, water heater, clothes dryer, or gas
appliance.
4.
Clean the engine and the entire tractor thoroughly.
NOTE: Use of a pressure washer or garden hose is not recommended
to clean your tractor. They may cause damage to electrical compo-
nents, spindles, pulleys, bearings or the engine. The use of water will
result in shortened life and reduce serviceability.
5.
Sharpen the blades so that the mower will be ready to use when
needed.
6.
Protect the metal surfaces. Repair scratches with the appropriate
touch-up spray paint. Brush a rust preventive oil on any unpainted
surfaces including the pulleys and blades. (Be careful not to get
any oil on the drive belts.)
7.
Clean and fully charge the battery, then disconnect the negative
cable at the battery to prevent possible discharge. Recharge the
battery periodically when in storage.
NOTE: Remove the battery if exposed to prolonged periods of sub-
freezing temperatures. Store in a cool, dry location where temperatures
are above freezing.
8.
Lubricate all lubrication points.
9.
Jack the mower up and store it on blocks to take the weight off of
the tires.
REMOVING THE TRACTOR FROM STORAGE
1.
Check the engine oil.
2.
Fully charge the battery, lower tractor off blocks, and inflate the
tires to the recommended pressure.
3.
Remove the spark plugs and wipe them off. Using the starter,
crank the engine to pump the excess oil out of the spark plug
holes. Replace the spark plugs and the ignition leads.
4.
If drained before storing, fill the fuel tank with clean, fresh
gasoline.
5.
Check the level of the engine oil in the crankcase and the
hydraulic reservoir tank.
6.
Start the engine and allow to idle for a few minutes to ensure
engine is operating properly.
7.
Drive the tractor without a load to make certain all the tractor
systems are functioning properly.
34
Publicidad
Solución de problemas
