Publicidad
RIDING MOWER PREPARATION
Remove the upper crating material from the shipping pallet, and cut
any bands or tie straps securing the riding mower to the pallet.
1.
Use the lift handle to raise the deck to its highest position.
1.
From just in front of the two rear tires, locate the transmission
bypass rods. Refer to Figure 1.
RH Transmission
Bypass Rod
2.
Pull one rod toward the front of the riding mower until the flange
on the rod is forward of the keyhole slot in the frame assembly.
3.
Lower the bypass rod into the keyhole slot and release so the rod
flange is against the front of the frame bracket.
4.
Repeat the above procedure to engage the other bypass rod on
the other side of the riding mower.
5.
With the bypass rods engaged and with the aid of an assistant,
carefully push the riding mower off of the shipping pallet.
6.
After moving the riding mower, disengage both bypass rods. Lift
the rod and guide the flange of the rod back through the larger
circular opening of the keyhole, then release the rod.
NOTE: The riding mower will not drive with the bypass rods in the
engage position.
7.
Remove the deck wash system nozzle adapter and oil drain tube
from the manual bag and store for future use.
Install Operator's Seat
To install the seat proceed as follows:
NOTE: The seat is shipped with the seat switch and seat pan attached.
8.
Cut any straps securing the seat assembly and the drive control
levers to the riding mower. Remove any packing material.
NOTE: Be careful not to cut the wiring harness connecting the seat
and the seat switch.
ASSEMBLY
Pull Out Bypass
Rod Then Lower
Into Slot
Keyhole Slot
Figure 1
9.
Remove the two shoulder bolts and lock nuts in the seat pan as
shown in Figure 2.
Nut
Rotate the seat into position and secure the seat into place with the
previously removed shoulder bolts and lock nuts. Be careful not to crimp
or damage the wire harness while installing the seat. See Figure 3.
Nut
9
Bolt
Figure 2
Bolt
Spacer
Wire Harness
Figure 3
Publicidad
Solución de problemas
