Main Unit Parts And Functions - Teac AI-303 Manual Del Usuario

A
Standby/on (¤) button
Press this to turn the unit on and put it in standby.
When the unit is turned on, the ring around the but-
ton lights blue.
o When this unit is in standby mode, it consumes
standby power. For this reason, we use the term
"standby" rather than "off".
B
PHONES jack
Connect a 3.5mm (1/8") stereo mini plug for head-
phones here.
o This headphone amp circuit uses a four-pole
connector with independent left and right for
grounding. Ordinary plugs with 3 or 4 poles can
be used.
o If headphones are connected here, audio will not
be output from the speaker (SPEAKERS) terminals
or SUBWOOFER OUT connector on the back of
the unit.
Wiring illustration
L+ R+ L−
C
SOURCE button
Use this button to select the input source.

Main unit parts and functions

R−
D
Input source indicators
The indicator for the source that is selected lights.
These indicators blink when an input signal is not
input properly.
This unit can play back linear PCM signals. It cannot
play back Dolby Digital, DTS, AAC and other formats.
Set the source device to linear PCM output.
E
Remote control signal receiver
This receives signals from the remote control. When
operating the remote control, point it at the remote
control signal receiver.
F
CROSSFEED knob
Turning this right will increase the amount that the left
and right sound signals are each mixed into the other
channel, making the overall sound more centralized in
the stereo field. Turning this all the way to the right will
make the sound mono. Turning this all the way to the
left will turn this function off (page 14).
G
VOLUME knob
Use this to adjust the volume. Turn it right to increase
and left to decrease the volume.
11