Cuisinart FP1300BE Manual De Instrucciones página 27

Main Work Bowl & Cover Operation
1. Place the food processor base on a dry, level worktop with the controls facing toward you. Do
not plug the unit in until it is fully assembled.
2. Place the Large Work Bowl on the base and use the handle to turn the bowl anticlockwise to
lock it into place.
3. To use the Small Work Bowl, first attach the Large Work Bowl to the base. Place the Stem Adapter
onto the shaft, then lower the Small Work Bowl over the adapter and into the Large Work Bowl.
Place your fingers in the recesses of the Small Work Bowl and turn slightly to secure, until the
bowl drops into place (it will still be possible to move the bowl slightly from side to side).
4. Place the workbowl cover over the large work bowl with the feedtube assembly shifted slightly
to the right of the handle.
5. Once the cover is fully seated, rotate it to clockwise to engage the lid-locking mechanism and
interlock. It should click into place. (Fig.2)
6. To remove the cover, turn anticlockwise until it will not turn any further, then lift to release.
NOTE: You cannot remove the work bowl before removing the work bowl cover.
Flat Work Bowl Cover Operation
The Flat Cover provides added convenience for recipes that do not require the 3 feed tubes, as
it is lightweight and there are fewer pieces to wash afterwards. You may find it useful when you
are preparing baked goods such as cakes, cookies, pies and breads. The Flat Work Bowl Cover also
doubles as the Dicing Kit storage lid.
NOTE: Do not use the Flat Cover with the Small Work Bowl & Small Chopping/Mixing Blade,
Slicing Disc, Shredding/Grating Disc, Dicing or Spiraliser attachments.
To Assemble the Flat Cover
Place the Flat Cover on the work bowl so that the Cuisinart logo written on the cover is face up
and readable. Then turn the cover clockwise to lock into place. Make sure the small cap is in place
before using.
To Disassemble the Flat Cover
Place one hand near the Cuisinart logo and one hand on the opposite end of the cover. Turn
anticlockwise to release.
A. MACHINE CONTROLS
High and Low Control Buttons
The High and Low controls are buttons that allow the machine to run until Off is selected.
1. Properly assemble the machine.
2. Add ingredients to the work bowl, either through the feed tube or directly into the bowl. Lock
cover into place.
3. Press the High or Low button. The blue LED light will illuminate and the motor will start.
4. Press the Off button when finished.
Pulse Button
The Pulse control is a button that allows the machine to run only while it is being pressed. This
capability provides more accurate control of the duration and frequency of processing. Unless
otherwise specified, a pulse should be about two seconds.
27