Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: Make certain the top of the wick adjuster and
the top of primary air tube are the same height.
If they uneven, the flames tend to be uneven,
too.
10
Tighten the three (3) wing nuts around the wick adjus-
ter.
11
Turn the wick adjuster knob to be sure the wick moves
smoothly up and down.
After replacing the wick, check the operation of the
automatic extinguisher by pushing down the safety
button.
Wick height should be 6 mm when wick adjuster knob
is turned fully clockwise. Be sure to check.
NOTE: If the wick does not move smoothly and easily, or
wick height is not in the range of 6-7 mm, do not
use the heater. Disassemble and repeat items 6
through 11.
NOTE: If any ragged edges appear on the top of the
wick, trim them with a scissors carefully. DO NOT
cut the body of the wick.
12
Install the heat chamber.
13
Replace the heater cover on the fuel tank and secure it
into position with three (3) screws. Replace batteries in
the battery holder. Be sure that the combustion cham-
ber is properly seated by moving the combustion cham-
ber handle left and right.
Once again, check the proper operation of the automa-
tic extinguisher.
NOTE: Before lighting a new wick for the first time, turn
the wick to its lowest position and allow the wick
to saturate with paraffin for about thirty (30)
minutes.
4
12
10
11b
6mm
12
11a
11c
13
Publicidad
