Publicidad
Idiomas disponibles
Idiomas disponibles
12
12C
12C
12A
12E
12B
12 PULL-OUT HOSE ATTACHMENT
From underneath sink, remove Protective Cap (12E). Push Quick Connector (12A),
located on the end of the Pull-Out Hose (12B) firmly upward onto the Receiving Tube
(12C), until unable to push any further. Pull down on the Quick Connector (12A). If the
housing and the Inner Collect (12D) separate slightly but do not pull off, the Receiving
Tube (12C) quick connect is secure.
13
13 SOAP DISPENSER INSTALLATION
From above sink, insert threaded Shank (13A) of soap dispenser body through Foam
Gasket (13B) and sink hole. From below sink, tighten Nut (13C) and thread on Bottle
(13D) to Shank (13A).
12D
12C
12A
12A
13A
13B
13C
13D
ENGLISH
14
14 SOAP DISPENSER HEAD INSTALLATION
Pour in liquid soap (not included) into the Shank Orifice (14A). Insert Pump Mechanism
(14B) into Soap Dispenser Body (14C). Install Dispenser Head (14D) by pushing firmly
onto Pump Mechanism (14B).
15
Water Supply Lines are not included. Please consult
manufacturer and/or its instructions for the correct
method of installation of supply lines and fittings.
CAUTION: Incorrect application of supply lines and fittings may
result in the failure or leak of the supply lines and fittings.
B
15C
1" Max.
(26 mm)
15B
C
15D
15E
15B
15 WATER SUPPLY CONNECTIONS
A. Thread Inlet Connectors (15A) into Water Supply Lines (15B).
B. Remove Protective Cap (15F). Gently separate hot and cold Faucet Inlets (15C),
approximately 1 in. (26 mm) apart. Connect Water Supply Lines (15B) onto Faucet Inlets
(15C). Hot water supply line goes to hot inlet fitting indicated by red tag.
C. Insert Clip (15D) into Inlet Connector Holes (15E) to secure water supply lines, as shown.
4
14A
15A
15C
15C
Red Tag
15A
HOT
COLD
15D
14D
14B
14C
A
15B
15C
15F
15A
15B
Publicidad
