Power Ratings - Briggs & Stratton 080000 Manual Del Operario

en
English
Emissions Control Service
For maintenance, replacement, or repair of emissions control devices
and systems, contact a qualified off-road engine repair establishment or
service technician. However, for "no charge" emissions control service, the
work must be done by a factory authorized dealer. Refer to the Emissions Control
Statements.
Carburetor and Engine Speed
Do not make adjustments to the carburetor or engine speed. The carburetor was
set at the factory to operate satisfactorily in most conditions. Do not change the
governor spring, linkages, or other parts to adjust the engine speed. If adjustments
are necessary, contact a Briggs & Stratton Authorized Service Dealer for servicing.
NOTICE: The equipment manufacturer specifies the maximum speed for the
engine as installed on the equipment. Do not exceed this speed. If you are not sure
what the equipment maximum speed is, or what the engine speed is set to from
the factory, contact a Briggs & Stratton Authorized Service Dealer for assistance.
For safe and correct operation of the equipment, the engine speed should only be
adjusted by a qualified service technician.
Troubleshooting
For assistance, contact your local dealer or go to BRIGGSandSTRATTON.com or
call 1-800-444-7774 (in USA).

Power Ratings

The gross power rating for individual gasoline engine models is labeled in
accordance with SAE (Society of Automotive Engineers) code J1940 Small
Engine Power & Torque Rating Procedure, and is rated in accordance with
SAE J1995. Torque values are derived at 2600 RPM for those engines with
"rpm" called out on the label and 3060 RPM for all others; horsepower values
are derived at 3600 RPM. The gross power curves can be viewed at www.
BRIGGSandSTRATTON.COM. Net power values are taken with exhaust and
air cleaner installed whereas gross power values are collected without these
attachments. Actual gross engine power will be higher than net engine power and
is affected by, among other things, ambient operating conditions and engine-to-
engine variability. Given the wide array of products on which engines are placed,
the gasoline engine may not develop the rated gross power when used in a given
piece of power equipment. This difference is due to a variety of factors including,
but not limited to, the variety of engine components (air cleaner, exhaust, charging,
cooling, carburetor, fuel pump, etc.), application limitations, ambient operating
conditions (temperature, humidity, altitude), and engine-to-engine variability. Due
to manufacturing and capacity limitations, Briggs & Stratton may substitute an
engine of higher rated power for this engine.
Warranty
Briggs & Stratton
®
Effective August 2022
Limited Warranty
Briggs & Stratton warrants that, during the warranty period specified below, it will
repair or replace, free of charge, with a new, reconditioned or re-manufactured
part, at the sole discretion of Briggs & Stratton, any part that is defective in material
or workmanship or both. Transportation charges on product submitted for repair
or replacement under this warranty must be borne by purchaser. This warranty is
effective for and is subject to the time periods and conditions stated below. For
warranty service, find the nearest Authorized Service Dealer in our dealer locator
map at BRIGGSandSTRATTON.COM. The purchaser must contact the Authorized
Service Dealer, and then make the product available to the Authorized Service
Dealer for inspection and testing.
There is no other express warranty. Implied warranties, including those
of merchantability and fitness for a particular purpose, are limited to one
year from purchase, or to the extent permitted by law. All other implied
warranties are excluded. Liability for incidental or consequential damages
are excluded to the extent exclusion is permitted by law. Some states or
countries do not allow limitations on how long an implied warranty lasts, and
some states or countries do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation and exclusion may not apply to
you. This warranty gives you specific legal rights and you may also have other
rights which vary from state to state and country to country * .
Standard Warranty Terms 1, 2
®
Vanguard ; Commercial Series
Consumer Use - 36 months
Commercial Use - 36 months
22
Engine Warranty
XR Series
Consumer Use - 24 months
Commercial Use - 24 months
All Other Engines Featuring Dura-Bore™ Cast Iron Sleeve
Consumer Use - 24 months
Commercial Use - 12 months
All Other Engines
Consumer Use - 24 months
Commercial Use - 3 months
¹ These are our standard warranty terms, but occasionally there may be additional
warranty coverage that was not determined at time of publication. For a listing
of current warranty terms for your engine, go to BRIGGSandSTRATTON.com or
contact your Briggs & Stratton Authorized Service Dealer.
² There is no warranty for engines on equipment used for prime power in place of a
utility; standby generators used for commercial purposes, utility vehicles exceeding
25 MPH, or engines used in competitive racing or on commercial or rental tracks.
* In Australia - Our goods come with guarantees that cannot be excluded under the
Australian Consumer Law. You are entitled to a replacement or refund for a major
failure and for compensation for any other reasonably foreseeable loss or damage.
You are also entitled to have the goods repaired or replaced if the goods fail to
be of acceptable quality and the failure does not amount to a major failure. For
warranty service, find the nearest Authorized Service Dealer in our dealer locator
map at BRIGGSandSTRATTON.COM, or by calling 1300 274 447, or by emailing
or writing to salesenquiries@briggsandstratton.com.au, Briggs & Stratton Australia
Pty Ltd, 1 Moorebank Avenue, Moorebank, NSW , Australia, 2170.
The warranty period begins on the date of purchase by the first retail consumer or
commercial end user, and continues for the period of time stated in the table above.
"Consumer use" means personal residential household use by a retail consumer.
"Commercial use" means all other uses, including use for commercial, income
producing or rental purposes. Once an engine has experienced commercial use,
it shall thereafter be considered as a commercial use engine for purposes of this
warranty.
No warranty registration is necessary to obtain warranty on Briggs &
Stratton products. Save your proof of purchase receipt. If you do not
provide proof of the initial purchase date at the time warranty service is
requested, the manufacturing date of the product wit be used to determine
the warranty period.
About Your Warranty
This limited warranty covers engine-related material and/or workmanship issues
only, and not replacement or refund of the equipment to which the engine may
be mounted. Routine maintenance, tune-ups, adjustments, or normal wear and
tear are not covered under this warranty. Similarly, warranty is not applicable if
the engine has been altered or modified or if the engine serial number has been
defaced or removed. This warranty does not cover engine damage or performance
problems caused by:
1. The use of parts that are not original Briggs & Stratton parts;
2. Operating the engine with insufficient, contaminated, or an incorrect grade of
lubricating oil;
3. The use of contaminated or stale fuel, gasoline formulated with ethanol greater
than 10%, or the use of alternative fuels such as liquefied petroleum or
natural gas on engines not originally designed/manufactured by Briggs
& Stratton to operate on such fuels;
4. Dirt which entered the engine because of improper air cleaner maintenance or
re-assembly;
5. Striking an object with the cutter blade of a rotary lawn mower, loose or
improperly installed blade adapters, impellers, or other crankshaft coupled
devices, or excessive v-belt tightness;
6. Associated parts or assemblies such as clutches, transmissions, equipment
controls, etc., which are not supplied by Briggs & Stratton;
7. Overheating due to grass clippings, dirt and debris, or rodent nests which
plug or clog the cooling fins or flywheel area, or by operating the engine without
sufficient ventilation;
8. Excessive vibration due to over-speeding, loose engine mounting, loose
or unbalanced cutter blades or impellers, or improper coupling of equipment
components to the crankshaft;
9. Misuse, lack of routine maintenance, shipping, handling, or warehousing of
equipment, or improper engine installation.
Warranty service is available only through Briggs & Stratton Authorized
Service Dealers. Locate your nearest Authorized Service Dealer in our
dealer locator map at BRIGGSandSTRATTON.COM or by calling 1-800-444-
7774 (in USA).
80114782 (Revision A)