Optika Italy SZ Serie Manual De Instrucciones página 31

5. Head holder can be installed in several ways according to
specific need of the user.
Installation mode n° 1: (Fig. 25-27)
Insert the rear part of the head support (round black part) ③ (Fig.
25) from the top into the hole of the horizontal arm ④ and screw
in the prevention knob ② from the bottom.
• This mode allows the installation of heavy heads (or with
heavy cameras installed on top of the head).
Installation mode n° 2: (Fig. 28-29)
Insert the rear part of the head support (round black part) ③ (Fig.
28) from below into the hole in the horizontal arm and screw in
the prevention knob ② from above.
④
Page 31
②
③
F ig. 25 F ig. 25
F ig. 26 F ig. 26
F F ig. 27 ig. 27
F ig. 28 F ig. 28