Optika Italy SZ Serie Manual De Instrucciones página 47

4. This arm can be lift up and down as shown. (Fig. 77).
• If the arm tends to automatically move to side, it may be re-
quired tension adjustment on the Articulating Arm to suit your
microscope arm swing to side position. This can be done by
using Hex Allen Wrench 2.5 mm supplied. (Fig. 78)
Adjusting the light intensity
Rotate the light intensity adjustment knobs ① to turn ON/OFF
and to increase / decrease the light intensity of each single LED
arm. (Fig. 79)
Page 47
F ig. 77 F ig. 77
F ig. 78 F ig. 78
①
F ig. 79 F ig. 79