Avidsen 100720 Manual De Instrucciones página 34

OVERVIEW
The unit can be programmed before or after installation.
The unit has three preset codes:
1. Administrator's code: 123456 – to program the unit (Setup).
2. User's code: 1234 - to disconnect the alarm system.
3. Duress Code: 1111 – to launch a silent program and disarm the unit. This application
has been conceived to notify telephone contacts without triggering the siren. This turns out
to be particularly useful in extreme cases where user is threatened by a robber who orders
to disarm the alarm in your house.
4. Door-lock code: not used.
We recommend changing the codes as shown later on in the main unit settings.
To access the Setup menu, enter [Administrator Code + Enter].
To deactivate the system, enter [User Code + Disarm].
To send a silent alarm in case you are threatened, enter [Duress Code +
Disarm].
How to use the Touch pad
DELETE
FORWARD
BACKWARD
SELECT / CONFIRM
ENTER
BACKWARD / BACK TO PREVIOUS SCREEN / DELETE
ESC
ARM Press Arm on the central unit to arm it. The central unit will beep to confirm that alarm system
is armed and this status is displayed with a text message on the LCD screen.
DISARM Enter the User Code and press the Disarm button to deactivate the alarm system. The
central unit will sound two confirming beeps.
HOME Press the Home button to enter the system in Home mode. The central unit will sound to
confirm that the system is in Home mode. All sensors set as Home Zone will remain deactivated
(see par. "Setup Zone").
Press the button #SOS for 3 seconds to trigger the alarm. At the same time, the central unit dials
SOS
the preset phone numbers and notifies the emergency.
CHIAMATA Press the Call button, enter the telephone number and press Enter to use the PSTN
line or press again the Call button to use the GSM line. Press the Call button for 3/4 seconds to
use the "Quick call" function and call the first stored number in the central unit without having
to dial each time.
RECORD allows you to store a customized voice message not related to the central unit function (e.g.
"Remember to buy milk"); to hear it, press RFID. To record your message, hold down the Record
button, the registration phase lasting max. 10 seconds will start after the beep.
RFID identifies the area to use the RFID badge and disarm the central unit. When the central unit
is disarmed, press the button to listen to any pre-recorded RFID message.
10
GB