Operation; Commissioning Of The Heater; Troubleshooting; Maintenance - welltherm WS Manual De Instalacion Y Uso

5 - Operation

5.1 - Commissioning the
heater
Condition:
Initial commissioning

5.2 - Troubleshooting

Identifying and rectifying
faults

5.3 - Maintenance

5.4 -Decommissioning
the heater
34
The receiver may only be positioned at the edge of the heating system
or attached to the ceiling.
CAUTION: DO NOT PLACE IN THE CENTRE OF THE BACK WALL
OF THE RADIATOR! DANGER OF OVERHEATING!
Switch on the power supply to the heater.
If you do not sense a feeling of warmth straight away, then
leave the heater in operation for an extended period of time until the
indoor climate becomes suitably pleasant.
– A pleasant feeling of warmth will be felt once all solid bodies have
been heated.
Activate all wireless control components that are to be used. Refer to their
operating instructions on how to do this.
Check whether the heater is covered or clad if it is not giving out any heat.
In such a case it is possible that the safety temperature limiters in-
tegrated into the heater have switched it off. If so, wait until after the
heater has cooled down. The heater will automatically switch back on.
The surface colour of the heater may alter due to pollution in the indoor air,
such as from cigarette smoke, fireplace/stove residues or cooking fumes.
• Clean the heater after it has cooled down and at regular
intervals using a
soap.
Caution! There is a risk of material damage if unsuitable cleaning agents
are used!
Switch off the power supply to the heater.
damp cloth and some solvent-free