Publicidad
Idiomas disponibles
Idiomas disponibles
Function menu settings
Press and for 3S to enter the setting interface
or return to the main interface. Short press to switch
setting options. After setting, long press and to
return to the main interface.
Parameter setting and definition
P02: Mileage unit
After entering the setting interface, then press to
switch to P02: press or to select 0 (MILE-default)
or 1 (KM).
P04: Sleep time
From 0 to 60 minutes, 0 means always on. After
entering the setting interface, then press to switch
to P04: press
or to select from 0 to 60 (Default: 5
minutes).
P06: Wheel diameter
Calculated by inch, the precision is 0,1. After entering the
setting interface, then press to switch to P06: press
or to select the diameter (Default: 10).
P07: Number of tachometer magnets
Range: 1-100. After entering the setting interface, then
press to switch to P07: press or to select the
number of the magnets (Default: 30).
P09: Zero start
After entering the setting interface, then press to
EN
14
switch to P09: press or to 0.
Note: The system default is 1 (non zero startups). After
startup, it defaults to gear 0. In order to ride safely, please
confirm to start in gear 1. Then press down the acceleration
handle while sliding with your feet to start riding.
P12: Strength setting
Range: 0 to 5. After entering the setting interface, then
press to switch to P12: press or to select the
strength (Default: 5).
P15: Motor drive signal percentage
Range: 1 to 100. After entering the setting interface, then
press to switch to P15: press or to select the
percentage (Default: 100).
P16: Enable cruise
After entering the setting interface, then press to
switch to P16: press or to select 0 (OFF) or 1 (ON).
After starting cruise, press the acceleration handle until the
cruise icon lights up. At this time, releasing the handle will
not stop the assistance. When shifting gears, braking or
pressing the acceleration handle again, you will exit cruise.
P99: Restore to initial settings
Enter the menu, short press the or key, the value
00099 flashes, and the display returns to the main interface
after long-pressing the key for 5 seconds, the setting is
successfully done.
EN
15
Publicidad
