Helmet Information - Lincoln Electric VIKING 2450ADV Serie Manual Del Usuario

This Auto-Darkening Welding Helmet will automatically change from a light
state (shade 3.5) to a dark state (Shade 5-13) when arc welding starts.
The filter automatically returns to a light state when the arc stops.
Match your welding application to the shade indicated on the shade chart.
(See Page 10)
• Operating temperature: 14°F ~ 131°F
• Do not use or open the auto-darkening filter if damaged by shock,
vibration or pressure.
• Keep the sensors and solar cell clean. Clean the filter cartridge using a
soapy water solution and soft cloth which should be damp but not
saturated.
This Auto-Darkening Welding Helmet is designed for use with GMAW, GTAW,
MMAW welding, or Plasma Arc and air carbon arc cutting.
The cartridge provides protection from harmful UV and IR radiation, in both
dark and light states.
The cartridge contains four sensors to detect the light from the welding arc,
resulting in the lens darkening to a selected welding shade.
• Do not use solvents or abrasive cleaning detergent.
• If cover lens is spattered or covered with dirt, it should be replaced
immediately.
• Use only replacement parts specified in this manual.
• Do not use the helmet without inside and outside cover lenses properly
installed.

HELMET INFORMATION

2
(-10°C ~ 55°C).