To avoid accident, cut off the power supply before operation according to the following
instruction:
1. The machine had been disinfected before departed from factory. Cleaning the
dispenser prior to installing a full bottle of water for the firs time.
2. Cleaning and draining instruction:
-1. Before cleaning, make sure the power switch in the O (off) position and unplug the
water dispenser.
-2. Vertically insert the bottle into the supporter on top of the machine.
-3. Open the taps, let about 1 liter water flows into a container.
-4. Removed the water bottle from the dispenser.
-5. Place a large bucket beneath the drain outlet. Removed the drain cover an allow
water to drain.
-6. After draining, replace the drain cover and you can use the machine.
Attention: The dispenser heats water to a temperature of approximately 85°C. It
can cause severe scalded. Please operation it carefully.
3. Sanitizing:
The machine should be disinfected with the disinfectant separately bought from
drugstore or marketplace according to the instruction manual of the disinfectant and then
clean it with water (see cleaning and draining instruction). Generally this should be done
every three months.
4. To remove mineral deposits:
Mix 4 liters water with 200g citric acid crystals inject into the machine and make sure the
water can flow out of the hot water tap.Switch on the power and heat it about 10
minutes, 30 minutes later, drain off the liquor and clean it with water for two or tree times.
Generally this should be done every six months.
Never disassemble this machine by yourself to avoid danger from damaged machine.
CL E A NI N G
English-7