Remote Control Connection; Using The Appliance - universalblue UVT1339-22 Manual De Instrucciones

ENGLISH
Select the model you have purchased from
the list..
Youtube link:
https://www.youtube.com/
playlist?list=PLWr7XjixBD4z5wryoYFEMFvDYKfkgIKlc
Or scan the QR code:
You can see the whole assembling
sequence in picture 04 on page 6.
Note: The images are for guidance only and
should be used to support the installation.
• Step 01: Open the carton box and take
out the fan (fig. 1).
• Step 02: Assemble the support plate on
the ceiling using two or more screw
anchors and
Attention: the provided screw are for
wood joist and concrete ceiling. (fig. 2).
• Step 03: Insert the support rod through
the upper cap and lower cap.
• Step 04: Insert the electric cables
coming out from the motor through the
• supportrod and connect them to the
screw terminal placed on the top
• of support rod.
• Step 05: Fix the support rod to the motor
using the pin and pin's nut. (fig. 3)
• Step 06: Hang the fan on the hook on
the support plate and connect the
electrical cable coming from the ceiling
to the screw terminal placed on the top
of support rod, make sure the receiver
must be insert into support plate(see
Remote control connnection).
• Step 07: Slide upwards the upper capand
fix it with the screw. (fig. 4)
• Step 08: Slide downwards the lower cap;
24
appropriate washers.
it must be supported by the motor. Fix it
with the screw. (fig. 4)
• Step 09: Disassembled the lamp plate
from the fan, please organize all the
wires carefully,and disconnect the
lamp connector. Assemble and align
the holes on the lamp plate to three
screws on the connect plate, set the
lamp shape between connect plate and
lamp plate.(fig.5)
• Step 10: Then tighten the three screws
on lamp plate connect the connector
together with the motor wire,Please
make sure the light kit can't be removed
after tighten the screws.(fig.6)
• Step 11: Place the light cover on the fan.
(fig. 7)

REMOTE CONTROL CONNECTION

See picture 06 on page 8.
L : AC IN 220-240V
N : AC IN 220-240V

USING THE APPLIANCE

This device is very easy to use and does
not require much knowledge. However, we
advise you to familiarize yourself with the
instructions below.
The fan has 6 power levels that can be
selected through the remote control. It also
has a timer of up to 8 hours.
REMOTE CONTROL (see picture 07 on page
8)
The device incorporates a remote control,
for a more comfortable and efficient use.
In order for the remote control to work, it
must always be aimed at the fan.
Before you start using it, please take a few
minutes to familiarize yourself with the
functions:
13. Button
set SUMMER mode function.
14. Button ALL OFF: Press this button to
turn off the fan and light.
15. Button : Press this button to turn
on and off the light. If you want to
change the light colour, press it until
: Press this button to