Door Alignment; How To Remove And Install The Refrigerator Doors - LG LTN16385PL Manual De Usuario

2. Use a flat head screwdriver to adjust the leveling screws
(see Figure A), turning clockwise to raise the side of the
refrigerator and counter-clockwise to lower it. It may take
several turns to adjust it to the inclination you would like.
NOTE: Having someone push against the top of the
refrigerator takes some weight
screws. This will make it easier to adjust the screws.
3. Open both doors again and check to make sure that
they close easily. If not, tilt the refrigerator slightly
more to the rear by turning both leveling screws
clockwise. It may take several more turns, and you
should turn both leveling screws the same amount.

DOOR ALIGNMENT

If the space between your doors is uneven, follow the
instructions below to align the doors:
1. Gently pry off the top hinge cover with a flat head
screwdriver and remove.
2. Loosen the top hinge bolts using a 10 mm or 13/32
inch socket wrench or open-end wrench.
3. Have someone hold the freezer door so the space
between the two doors is even, and retighten the top
hinge bolts.
4. Replace the top hinge cover.
HOW TO REMOVE AND INSTALL THE
REFRIGERATOR DOORS
If entrance is lees than 32 inches wide, the refrigerator's
door will need to be removed.
IMPORTANT: Before starting, turn off and unplug the
refrigerator. Remove all food and the racks from the
doors.
TOOLS YOU MIGHT NEED OR USE
10 mm
13/32 in
3/8 in
Hex Socket Wrench
Flat Head Screwdriver
WARNING
ELECTRICAL SHOCK HAZARD
Before you begin, either unplug the refrigerator or
turn off the power at the circuit breaker or fuse box.
Remove food and any door rack from the refrigerator.
Failure to do so could result in death or serious injury.
1. Removing the Freezer Door
• Using the Phillips screwdriver, loose the screw from the
top-hinge cover (a) after this remove it with a flat head
screwdriver (b) (See Fig. 1).
REFRIGERATOR INSTALLATION
off the leveling
Phillips Screwdriver
No. 2
Fig. 1
• Using either a 10 mm or 13/32 in. socket wrench,
remove the three bolts and lift off the top hinge. Set
parts aside (See Fig. 2).
Fig. 2
• Carefully lift up the freezer door. Place the door on a
non-scratching surface.
Fig. 3
2. Removing the Refrigerator Door
• Loosen and remove the two bolts using the socket
wrench (See Figure 4).
Middle Hinge
Bracket
8
(a)
Screw
(b)
Fig. 4