Descargar Imprimir esta página

Booster Mode; Switching Between Harness And Booster Mode; Harness Mode To Booster Mode - Britax ONE4LIFE CLICKTIGHT Guia Del Usuario

Ocultar thumbs Ver también para ONE4LIFE CLICKTIGHT:

Publicidad

Idiomas disponibles

Idiomas disponibles

Before traveling, verify that the:
9 Recline indicator is still in acceptable range.
9 Harness straps are not twisted.
9 Harness is snug.
9 Buckle is fastened.
9 Chest clip is at the child's armpit level.
9 Bulky coats, jackets, and/or bulky sports equipment are removed.

Booster Mode

Warning! Use only
IMPORTANT:
the vehicle's lap and shoulder
belt system when restraining the
child in this booster seat.
1� Adjust the headrest to the
highest position.
2� Place child in the child
restraint with child's back
flat against the seat.
3� Pull the vehicle belt out
and route the shoulder part
through the red
BOOSTER
mode shoulder belt guide.
4� Adjust the headrest so
that the vehicle shoulder
belt lays straight across the
child's chest.
NOTE: The shoulder belt
guides MUST be above the
child's shoulders.
5� Route the vehicle belt
through the
BOOSTER
mode lap belt guide and
across the child.
6� Fasten the vehicle belt.
Remove slack from the belt.
36
Table of Contents
7� Ensure the shoulder part
lays across the center of
the child's chest, above
the child's shoulder and
does not contact the child's
neck (A). The lap part of the
vehicle belt is routed low
across the child's upper
thighs (B).
Before traveling, verify that the:
9 Vehicle belt is not twisted.
9 Shoulder part of vehicle belt is routed through the shoulder belt guide
above the child's shoulder, lies across the center of the child's chest and
does not contact the child's neck.
9 Lap part of the vehicle belt is routed low across the child's upper thighs.

Switching between Harness and Booster Mode

Harness Mode to Booster Mode

NOTE: It is not necessary to use lower anchors and top
tether to position this child restraint in
If using the lower anchors and top tether to position this
child restraint in
follow
harness. Refer to page 31 Using Lower Anchors and
Top Tether (LATCH) in
1� Raise the headrest to the
highest position.
2� Loosen the harness. Press
the harness release button
(A) and pull both harness
straps forward (B).
NOTE: Make sure enough
harness adjuster strap is left
hanging from the front of the
seat. Use the inner slot as a
reference point to measure
how much harness strap can
be left hanging from the front
of the seat.
BOOSTER
mode, it is recommended to
BOOSTER
Mode Installation before storing the
BOOSTER
Table of Contents
A
B
BOOSTER
mode.
Mode.
B
A
Inner Slot
37

Publicidad

loading