Publicidad
Idiomas disponibles
Idiomas disponibles
CONFIGURING MEASUREMENTS
STARTING A MEASUREMENT
Press the Start / Stop button to start the measurement. You can only press the Start / Stop button when it is green.
It turns red for the duration of the measurement then turns off.
For insulation measurements and dielectric tests, press and hold the Start / Stop button until it turns red.
START
STOP
If you have chosen automatic duration, the stopwatch indicates the elapsed time.
If you have not chosen automatic duration, wait until the measurement is stable then press the Start / Stop button
again to stop it.
To report an error, the Start / Stop button blinks. If you press it, the error will be displayed in plain text.
READING THE RESULT
The blue rectangle on the display contains all the settings
to configure. They vary according to the measurements.
Tap it to change the settings.
START
STOP
Main measurement result.
Measurement validation (
Other measurement results.
Setup reminder.
15
START
STOP
).
,
or
Publicidad
