Setting The Temperature Controls; How To Install; Installation For Use - Qilive Q.6333 Manual De Instrucciones

4.2 SETTING THE TEMPERATURE CONTROLS

• To set the temperature
Set the desired cooling temperature by touching the symbols above "UP/DOWN"
program. Each depression of the symbol will scroll through the available temperature
setting in increments of 1 degree. The temperature selected will flash in the LCD display
for approximately 7 seconds, then revert back to display the temperature of the internal
cabinet.
• The temperature setting can be adjusted from 5°C~18°C (40°F ~ 66°F).
Flashing LCD = Set Temperature
Steady LCD = Cabinet Temperature
5. INSTRUCTIONS FOR USE
• Clean the appliance, and be thorough, especially in the interior (See HOW TO
CLEAN).
• In case the interior accessories are not correctly placed,
rearrange them as described in chapter DESCRIPTION
OF THE APPLIANCE.
• This device is exclusively intended for storage of wines,
not for cooling or freezing of food.
• The shelves have been designed in such a manner to
allow the most effective utilisation of energy of device´s
cooling system.
• Therefore, we recommend not to change this design
of shelves when using the device /where possible/
to maintain the most effective utilisation of energy of
device´s cooling unit.
• If the ambient temperature is 25 °C and no bottles are in the wine storage, it will take
approx. 30 minutes to increase the interior temperature of the wine storage from 5 °C
to 12 °C. Under the same circumstances, it will take approx. 60 minutes to reduce the
interior temperature of the wine storage from 12 °C to 5 °C. The lower the ambient
temperature, the less time is needed to reach the required temperature.
• The compressor continues cumulative operation as long as 12 hours, then its
operation will be automatically discontinued in order to allow defrosting.

5.1 How to install

WARNING! To avoid a hazard due to instability of the appliance, it must be
fixed in accordance with the instructions.
1. Install refrigerator in a convenient location away from extreme heat and cold. Allow
sufficient clearance between the refrigerator and side wall so the door will open
without obstruction. Wine cooler is designed for recessed installation.
2. Select a space with strong level floor.
3. Allow 2 inches (5cm) of space between the refrigerators side & wall and 4 inches
(10cm) between back & the wall.
11
EN