Publicidad
Idiomas disponibles
Idiomas disponibles
EN
C1
C3
ASSEMBLE AS A BLOWER (See figure C)
Slide blower tube to the tool main part until the lock
button go back to the original position.
ASSEMBLE AS A VACUUM
1. Locate roller on vacuum tube (see figure D)
D1
D3
2.Connect two vacuum tubes by screws (see figure E)
E1
E2
C2
C4
D2
E3
3. ASSEMBLE VACUUM TUBE ON TOOL (SEE
FIGURE F)
3.1 Pull the lock button forward and keep the vacuum gate
open.
3.2 Insert the vacuum tube clip on the main tool clip.
3.3 3.4 Pull the lock button forward until the vacuum tube
fully inserted into tool. Then release the button.
F1
F3
4. ASSEMBLE BAG (SEE FIGURE G)
G1
G2
G4
COMO ENCENDER/PARAR Y AJUSTAR LA
VELOCIDAD
Warning:
Before you begin, make sure that the on / off
switch is in the off position and that all compo-
nents are properly assembled as described in this manual.
If the tool is used as a blower, make sure the vacuum door
is completely closed; If the tool is used as a vacuum clea-
ner, make sure the bag is zipped closed. 1. Place 2 20V
batteries 2. Press the on / off button and the appliance will
start working. 3. Roll the speed adjusting switch according
to different working conditions 4. To stop the appliance
4
F2
F4
G3
Publicidad
