Adjusting The Steering Angle; Basic Setting Of The Chassis According To The Rider Weight; Setting The Fork Compression - SHERCO 250-300 SE/R 2013 Manual Del Propietário

adjUsTing THe sTeering angle

BasiC seTTing OF THe CHassis aCCOrding TO THe rider
WeigHT
Standard weight of the-
rider (with equipment)

seTTing THe FOrK COMPressiOn

All manuals and user guides at all-guides.com
The steering angle can be changed using the set
screws located on the bottom of the steering
column.
Loosen the nut
until you have the steering angle desired.
1
Tighten the nut and do the same operation on
the other side.
2
Steering angle
lock nut
If the weight of the rider is above or below the
75 à 85kg
standard, compensate by changing the stiffness
of the springs (forks and shock).
Screws
when it is compressed. Turning in the screw-
1
clockwise increases the hydraulic force (and
vice versa).
Remove the caps
the fork.
2
Turn screw
back the number of clicks required.
Adjusting the compression
Sachs Series Gold Ø48mm
Adjustable compression
WP Suspension USD
Ø48mm
Replace the cap
and tighten the screw
1
M8
determine the behavior of the fork
2
located at the lower end
1
clockwise to the stop and go
2
.
1
2
20Nm
12 clics
20
Comfort
clicks
13
Standard
clicks
8
Sport
clicks
95