Publicidad
Idiomas disponibles
Idiomas disponibles
■
At the end of the cycle, the liquid is drained away and the
boiler is cleaned.
■
At this point, the scale-removal cycle has ended. When the
LED on the display stops flashing and its light stays on, the steam
bath can be used again.
NOTE: Do not turn off the main switch until the scale-removal cycle
is complete, because this would prevent boiler washing. If the scale-
removal cycle is started accidentally, turn off the main switch for
a few seconds and then turn it back on, so as to restore the steam
bath operation.
ALARM
Connection to the alarm circuit must be made during installation,
by qualified personnel, in compliance with the instructions set forth
in the installation manual.
■
When the button (2) is pressed, the alarm signal is activated
immediately (bells, buzzers, lights etc.): this lasts about 15 sec-
onds, and then it automatically stops, however, it can be inter-
rupted at any moment by pressing the button again.
■
If, at the moment the alarm starts and the "steam bath" func-
tion is operating, it is immediately interrupted.
■
By pressing the button (2) during the "steam bath", this func-
tion is interrupted even if the shower enclosure has not been
connected to an alarm circuit.
/ solution
THE DISPLAY IS OFF.
SURE
shower head.
specifications on the technical pre-installation data sheet.
and/or lime scale.
THE HYDROMASSAGE PROVIDES INADEQUATE PRESSURE
ice Centre to check the pressure and the water system capacity.
and cold water are well-balanced. If the values are different, it is ad-
visable to contact your plumber.
mestic system; if the problem persists, switch off the system and
contact the Jacuzzi® Service Centre.
GRAMMES.
If there is no water during the steam bath, or if the water goes below
the safety level, the function is interrupted and the LED on the dis-
play begins to flash quickly, indicating the alarm condition.
If the safety level is not restored after about 2 minutes, the function
is switched off and the emptying and washing of the boiler starts.
To use the steam bath again, see the related chapter.
the water does not reach the operating level. In this case, the func-
tion waits for about 3 minutes, and then, if the water level is still
insufficient, the function is interrupted and the emptying and wash-
ing of the boiler starts.
To use the steam bath again, see the related chapter.
16
16
-
-
-
-
Publicidad
