Publicidad
Idiomas disponibles
Idiomas disponibles
6
6
Safety Notes
6 Gloves should be worn during installation to prevent
crushing and cutting injuries.
6 The hot and cold supplies must be of equal
pressures.
Installation Instructions
• The fitting must be installed, flushed and tested after
the valid norms.
• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The fittings must be mounted in an insulated manner
and with sound insulation.
Assembly (see page 31)
Install body with G 3/4 outlet pointing downwards.
Depth of fitting: 68 mm to 96 mm.
extension set 28 mm
Note: When installation is complete ensure
that the mixer is turned off!
A Direct wall installation.
B Direct wall installation with 10 mm adjustable moun-
ting studs.
C Brick wall installation.
4
English
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Connections G 1/2:
Hansgrohe mixers can be used together with
hydraulically and thermically controlled continuous flow
heaters if the flow pressure is at least 0,15 MPa.
The product is exclusively designed for drinking water!
Symbol description
Assembly see page 31
Do not use silicone containing acetic acid!
Adjustment
To adjust the hot water limiter on single lever
mixers, please see page 32. No adjustment
is necessary when using a continuous flow
water heater.
Dimensions (see page 33)
Flow diagram
(see page 33)
Tub outlet
Shower outlet
Final assembly (see page 35)
Spare parts (see page 34)
Special accessories
extension set 28 mm (32498000) order as
an extra
Test certificate (see page 36)
max. 1 MPa
0,1 – 0,5 MPa
1,6 MPa
max.80°C
65°C
cold right - hot left
Publicidad
