Installation Instructions - Maytag MAT20PDFGW Instrucciones

2. Lay fascia panel face down on appliance top panel to provide
access to User Interface Control Board.
3. SAID code is printed on the Label located on Wi-Fi Module.
4. Replace fascia panel onto appliance with the two screws
previously removed (Refer to illustration, step 1).
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
5. Plug appliance into a grounded 3 prong outlet or reconnect
power and enter the USB Menu; see page 18.

INSTALLATION INSTRUCTIONS

WARNING
Excessive Weight Hazard
Use two or more people to move and install washer.
Failure to do so can result in back or other injury.
It is necessary to remove all shipping materials for proper
operation and to avoid excessive noise from washer.
10
1. Move washer to within 4 ft (1.2 m) of its final location; it must
be in a fully upright position.
NOTE: To avoid floor damage, set washer onto cardboard
before moving it and make sure lid is taped shut.
1.2 m
(48")
2. To avoid damaging floor, place cardboard supports from
shipping carton on floor behind washer. Tip washer back
and place on cardboard supports. Remove shipping base.
Set washer upright.
IMPORTANT: Removing shipping base is necessary for proper
operation. If your washer includes a sound shield, please refer
to the instructions included with the sound shield to install it
at this time.
NOTE: Keep shipping base in case you need to move washer
later.
3. Remove tape from washer lid, open lid, and remove cardboard
packing tray from tub. Be sure to remove all parts from tray.
NOTE: Tray must be removed prior to plugging the washer
into an outlet. Keep tray in case you need to move washer
later.