Installing The Air Distribution Box - Furrion CHILL FACR13LPSA-PS Manual De Usuario

Installing the Air Distribution Box

NOTE: The installation of the air distribution box is same for
both ducted and non-ducted structures.
The rooftop unit is fixed on the RV roof using 4 long bolts
through the mounting frame from the interior of the RV ceiling.
1. Check the gasket alignment of the rooftop unit inside the
RV over the roof opening and adjust as necessary by lifting
and moving slightly.
Roof Opening
2. Reach up into the return air opening and pull down the
rooftop unit electric cord. Ensure all terminated wire ends
specified in "Preparing Wire Connections" section are
accessible.
12V+ from Furnace
(optional)
Return to Furnace
(optional)
Thermostat Wire
(4-wire min.)
115VAC
Power Cord
3. Assemble the lower duct divider to the mounting frame
(C-FACR12SA-A01 [2022120382]).
NOTE: Dispose the existing mounting frame that go with
air distribution box and replace with the new one.
CCD-0007273 Rev: 11-04-22
Roof Opening
±12VDC
Rooftop Unit
Wires
Cable
4. Install the assembled mounting frame and the lower duct
divider into the rooftop opening. Make sure the "THIS WAY
FRONT" mark is facing front (the direction of the vehicle)
while installing.
5. Fix the assembled mounting frame and lower duct divider
into the rooftop unit using 4 bolts provided. Evenly tighten
the four bolts to a torque of 40 to 50 inch pounds. This will
compress the roof gasket to approximately ½ ".
NOTE: If bolts are left loose there may not be an adequate
roof seal or if over tightened, damage may occur to the
rooftop base or mounting frame.
6. Remove the film off the double sided sticky tape found on
the top inner side of the lower duct divider.
Peel off the film
- 7 -